Very nice quality machined dovetail bar StellaMira and very nice service from FLO. Recommend!

Excellent quality at a very reasonable price. My William Optics tube rings fit perfectly. Very happy with this purchase.

as i done before, i ordered at www.firstlightoptics.com and in no time i recieved my order, all in good time for darker nights

This item is a perfect fit , I had it attached to the telescope in 30 mins of receipt of it, very good quality and value for money. A perfect fit on my skywatcher mount. Thanks FLo for the right advice on this issue.

I wanted a short losmandy plate for an 80mm refractor so my scopes had the same saddle plate fitting. Didn't want a green one and black was the best option.

I’ve got two of these and think they’re worth the money. Adds a bit more stability over a vixen mount, which can be a bit fiddly to get on the saddle when there’s a bit of weight on the scope.

As I have a SkyWatcher Alt-Az EQ6, I wanted a solid plate to fit the Losmandy/Dovetail mount head. This delivers for me too because as I have a WO 80mm Refractor and ‘scope rings, the plate has been designed to easily accommodate the rings at various locations. Great service from FLO as my previous selection from FLO was returned under the 30 day returns policy, and another selection dispatched. Thanks to Steve for his assistance.

I bought this losmandy bar for my skywatcher quattro and I can't fault it. Fully adjustable so should fit lots of tube assemblies. Held very sturdy. Hats off to flo for super delivery and packing.

Got one mounted on the top and bottom of my Stellamira 90mm Triplet. Makes my whole set up rock solid. I am only using the 7.9" versions but I think I may need the longer one on the bottom when I change to a mono camera and filter wheel to make it balance easier. One thing to note the countersunk holes arn't deep enough to fit the usual bolts flush with the bar so I had to use the button head type, not a problem though and the drawing does show the dimensions.

Arrived in good order, very well wrapped in bubble wrap. Note that the photo and drawing don’t match. The drawing has two M6 countersunk holes (one on either end), while the photo has a hole only on one end. The photo matches the product. For me this isn’t a problem, as I will be using the slot.